Another ar15 huild

I have begun amassing parts for another 7.62x39 build. I am going with quality components! This is what has arrived thus far.

Upper
Yhm stripped 7.62x39 upper
YHM 7.62x39 Caliber Marked Upper Receiver Assemblies (D/C BY MFG) only mine was stripped no dust cover or forward assist.

Lower
Spikes tactical punisher lower
http://ift.tt/2ucDw5G

Barrel 16" Faxon nitrided barrel 1:8 twist
http://ift.tt/2udelQe

Bolt and bolt carrier group nitrided
http://ift.tt/2ud5u0X

Gas tube
Spikes tactical nitrided midlength
http://ift.tt/2udfesl

BCM enhanced lower parts kit. I'm going to sell the pnt trigger I'll tell why later on in this post the grip is going on my other AR
Bravo Enhanced Lower Parts Kit-FDE BCMGunfighter AR-15 Enhanced .223 23% OFF

Battle arms development take down pins
BAD-EPS (Enhanced Pin Set) AR15 | Battle Arms Development

Delton Delta ring assembly kit
http://ift.tt/2ucZFRp

Magpul aluminum trigger guard
http://ift.tt/2ucZFRp

That is what has arrived thus far. This is going to be an ongoing project that probably won't be completed until summer of next year as I've got to get the parts bought and paid off a piece or two at a time. I'll be going with the following parts listed below. Going forward of course.

Elftmann service trigger
http://ift.tt/2ud7V3H

Why the elftmann? Because it has a heavy hammer and full powered hammer spring. The only lightweight springs it has is the trigger return spring and disconnector spring. The adjustment pull weight is adjusted by adjusting the trigger return spring and disconnector spring. The hammer spring is non adjustable. This should allow for good ignition of hard berdan primers!

Kns anti walk pins
http://ift.tt/2ud2PEz

Handguard Midwest industries drop in at 6.6 ounces
https://www.midwestindustriesinc.com...mi-18m-blk.htm

Muzzle brake I'm going with VG6 precision gamma
GAMMA 300BLK | VG6 Precision

As far as sights go I'm probably going to go with Troy flip up rears I haven't decided whether I want the regular or tritium.

As far as optics go I'm going to go with an aimpoint pro with a primary arms 3x magnifier I think!

I'll be using a magpul ctr with Limbsaver and a magpul miad grip. As far as safeties go I'm going to use the battle arms development standard safety.

I'll be using a strike industries enhanced bolt catch and strike industries forward assist. The mag release button will be a battle arms development enhanced. The charging handle will be an axts talon.

I'm going to have custom engraving done on the lower.

Sent from my RCT6303W87DK using Tapatalk

Let's block ads! (Why?)

Another ar15 huild